flightaware prostick planeplotter mode s

Pre-built complete PiAware kit (pre-loaded Pi, Pro Stick, filter, and power/cables) with indoor antenna (eBay).USB 2.0 Flash Memory Card Reader MicroSD (DX).ADS-B 1090MHz Band-pass SMA RF Filter (eBay).FlightAware Pro Stick USB ADS-B Receiver + Cable + Filter + Antenna (eBay).Indoor Antenna MCX plug with a SMA adapter (eBay).

FlightAware Pro Stick USB ADS-B Receiver (eBay).Power Supply for Raspberry Pi (Raspberry Pi).Raspberry Pi 3/4/Zero Computer (Raspberry Pi).If you are in an area known for high voltage spikes consider an 800 joules surge protector.The Raspberry Pi is vulnerable to voltage spikes so consider a surge protector to prevent damage.If you live in an urban environment or a location that has a lot of radio noise this will help filter out that excess signal.Skip the step to program the micro SD card.If you use a telescoping mast antenna be sure to collapse it to a quarter wavelength of 1090 MHz (6.9 cm) to maximize reception.Īdditionally, you can choose to purchase or find the following items but they are not required.If using the FlightAware USB adapter be sure the antenna has an SMA connector. An indoor antenna can be purchased to start.Hint: If you are choosing between the FlightAware Pro Stick and the Pro Stick Plus remember the Plus has an on-board filter that works well in locations that have a lot of radio noise, such as urban environments.The USB SDR (Software Defined Radio) ADS-B (Automatic Dependent Surveillance-Broadcast) receiver translates the 1090 MHz radio signal into something the computer can understand.USB SDR ADS-B Receiver (FlightAware Pro Stick or Pro Stick Plus recommended).If your computer does not have a built-in SD card reader/writer, you will need the optional USB SD card reader/writer.5.1 Volts 2.5 Amps power supply recommended.To build a PiAware, you must obtain the following components:

Flightaware prostick planeplotter mode s